BILT Speaker

BILT Speaker
RevitCat - Revit Consultant

Wednesday 12 June 2013

Revit Step Pattern Repeaters Part 2

Further to my recent post of 6 June on Revit Step Pattern Repeaters, here are a couple more methods to achieve step repeaters:

Step Patterns Method 3

  • The previously created 1 point adaptive box could have an additional parameter added to it - to allow it to be offset to the right from its centrepoint origin.  At its simplest it just needs a parameter from centre to left side - if set at half the width value it will be centred;  if set at zero it will be offset by half its width.  You could put in a formula to make it offset using a checkbox but its not really necessary.

  • Create a new type that is offset to the right by half its width.
  • Place a centred type box on a node of the divided surface
  • Place an offset type box on the node above it on the next row

  • If you try to "repeat" this it will only create a linear pattern;  so you need to teach Revit what you want - place two additional boxes in a cluster of four (two of each type)

  • Select all four boxes and click on the "Repeater" (array) command to get a two directional step pattern.
  •  This will create four separate interlocking repeaters

  • The edges will not be finished correctly, so you need to create a new half width offset box and swap out the overhanging edge pieces.

  • NB. If you change the number of divisions on the surface, you cannot control where the half width types appear in the overall pattern.

Method 4

  • If you want to create something more complex than a box on a rectangular surface grid, you may need to create an adaptive component that has multiple adaptive placement points 
  • Although this example is still a box, it has 3 adaptive points - the first two set out the left hand edge, and the third point the bottom right corner and length (reporting parameter).  The overall box length is calculated at twice the length between the adaptive points 1 and 3
  •  The adaptive component needs to be placed on 3 nodes on the divided surface in the correct order

  •  If you repeat this component, it will make a rectangular pattern, which is not stepped.  So you need to place three more adaptive boxes in the final pattern that you require

  •  Select all four boxes and click on the repeat command - to get a step pattern

  • The edge boxes on the right hand side, need to be individually exchanged for half size boxes;  the left side needs to have new half-sized adaptive component boxes placed in alternate gaps.  It should be possible to place just the first two and then repeat them vertically.
  • Although this method is more complicated, the principle it shows would allow more complex patterns than the one point adaptives.  For example, if you taper the surface grid, the length of the box varies according to the node spacing

  • If you created a 4 point adaptive box, you could get it to distort itself to fit properly on a tapered grid

For methods 1 & 2 refer to previous post below:
Revit Step Pattern Repeaters

For information on how to achieve particular repeater patterns of adaptive components on a divided surface refer to:
Single Point Repeaters

1 comment:

  1. Good afternoon,

    My name is Darlan, I'm a student of civil engineering. I am currently starting at revit and dynamo and would like to develop a routine to optimize the launch of bricks considering the walls with the door and window openings already existing in the architectural project for my final work.
    Would this method consider the openings?

    I would be grateful for the help.

    Best regards,

    Darlan Borges.